Auto Switches
Auto Switch D
Safety Instructions Auto Switches/Precautions Plug-in Connector Assembly/How to Use DIN Terminal
Green Procurement (RoHS)
Green Procurement (RoHS)
| Series | Type | Features |
|---|---|---|
| D Series | Solid state auto switch | General purpose type 2-color indicator 2-color indicator with diagnostic output Water resistant 2-color indicator With timer |
| D Series | Reed auto switch | General purpose type 2-color indicator |
Analog Auto Switch and Display Sensor Monitor D-MH1□
-
・Outputs the analog voltage according to the actuator stroke position
・A single switch can discriminate between max. 3 position points.
Discriminable resolution: ±0.1 mm ∗ Within the high-resolution range
・Detection position setting can be done away from the actuator.
・Analog voltage output (1 to 5 V)
・Can also be used with the analog auto switch single unit
・Reduced setting labor
・No need to fine-tune the switch mounting position
・Easy adjustment even in narrow places and on moving parts
・Improved productivity
・Gripper fully open → gripping → gripping failure detection
・Detection of gripper finger wear
・Minimized lead wire disconnection risk
| Series | Type | Description |
|---|---|---|
| D-MH1AD(V) | Analog auto switch | Analog output sensor (1 to 5 V) |
| D-MH1BN | Sensor monitor | Display sensor monitor, NPN 2 outputs |
| D-MH1BP | Sensor monitor | Display sensor monitor, PNP 2 outputs |
Trimmer Auto Switch D
-
・Easily distinguish workpieces with a single auto switch
・Minimum detectable adjustment width: 0.5 mm
・Applicable to the short stroke cylinder
The detection of the extended and retracted end positions can be made by a single auto switch.
This switch can be used when two auto switches cannot be mounted due to a short stroke.
| Series | Type | Mounting |
|---|---|---|
| D-M9K | Sensor unit | Direct mounting (Round groove) |
| D-Y7K | Sensor unit | Direct mounting (Square groove) |
| D-F7K | Sensor unit | Rail mounting |
| D-R□K | Amplifier unit | - |
